Yokogawa DAQWORX - Manual (Page 98)

2-68 IM WX103-01E
Y-Axs Type
You can select linear or logarithmic scale for the Y-axis when displaying the waveforms.
Linear Logarithmic
Maxmum and Mnmum Values of the Y-Axs and the Dsplay Format of the
Scale Values
Specify the maximum and minimum values of the Y-axis scale. The scale values can also
be displayed using logarithmic format as shown below.
Select the exponential
format
Selectng the Dsplay Zone of the Waveform
You can select from the following. In the Zone setting on the General Display Settings
window, assume the bottom and top edges of the waveform display area to be 0% and
100%, respectively, and set the waveform display position by specifying the minimum
value (0 to 99%) and the maximum value (1 to 100%).
• User Zone
Displays each waveform at the position specified by Zone on the General Display
Settings window. A single Y-axis scale of the active waveform is displayed.
Select user zone
Click the bar to specify the
Y-axis you wish to activate
Displays the active Y-axis scale
Indicates the active Y-axis
Set the display zone
• Edit Zone
Like the user zone, each waveform is displayed at the position specified by Zone
on the General Display Settings window. However, you can change the zone on the
Trend Monitor window. A single Y-axis scale of the active waveform is displayed.
Select edit zone
Drag the knob to change the minimum/maximum
value of the zone separately
Drag the bar to change the zone position without
changing the zone width
2.10 Startng/Stoppng Data Montorng and Dsplayng the Montor