Yokogawa DAQWORX - Manual (Page 108)

2-78 IM WX103-01E
Explanaton
Savng Setup Data (Project)
When the Logger is started, the screens are displayed according to the setup data of
the project file that is automatically created (latest.mxe in the MXLOGGER folder). In
this case, the setup specified on each screen is automatically saved when the Logger is
closed.
If you save the setup data (project) as a project file by assigning a name and you open
the project file, the setup specified on each screen is not automatically saved when the
Logger is closed. To save the setup data, you must choose Save from the File menu.
Save Destnaton
The default save destination varies depending on the system that is running.
Fle Name
The extension is .mxe. The default file name is NewProject1.mxe.
Creatng a New Project
Create a new project when you wish to monitor the measured/computed data using new
settings.
Prnt Contents of Setup Data
The following figure show how the setup data is printed.
2.13 Savng/Loadng and Prntng Setup Data (Project)