IAI America E-Con - Manual (Page 5)

Table of Contents
Safety Guide ··········································································· · ······················· 1
1. Overview ············································································ · ······················ 8
2. Interface Specifications ······················································ · ························· 9
3. X-SEL-J/K/P/Q/JX/KX/PX/QX············································· · ······················· 10
10
10 3.1 Remote device station····················································· · · ················ ·····
3.1.1 Models ········································································· ················ ··
(1) Compact type (J type) ························································ ················ 11
(2) General type (K type) ·························································· ··············· 12
(3) P/Q type········································································ ················· ·13
3.1.2 CC-Link board ·································································· ················ 14
(1) Names of each part ························································· ················ ··14
(2) Rotary switches ···························································· · · ··············· ···15
(3) Display of monitor LEDs ······················································ ·············· · 16
3.1.3 Setting of I/O parameters (assignment of I/O ports) ··································· 17
(1) Board installation positions (slots) and parameter numbers ························· 17
(2) Factory-configured parameters (standard setting)······································ 19
(3) Factory-configured parameters of P/Q type·············································· 20
3.1.4 J/K type controller parameter setting examples········································· 21
(1) CC-Link connection of standard I/O ports ················································ 21
(2) Combined use of CC-Link board and I/O board········································· 23
3.1.5 P/Q type controller setting examples ······················································ 27
(1) Setting examples when only CC-Link is used ··········································· 27
(2) Setting examples when CC-Link board and I/O board are used in combination 29
3.1.6 X-SEL I/O port numbers ······································································ 33
3.1.7 Correspondence between X-SEL I/O port number and PLC address ············· 34
(1) When the number of I/O points is set to 96 or less: ···································· 34
(2) When the number of I/O points is set to 112 or more and 192 or less: ············ 34
(3) When the number of I/O points is set to 208 or more and 256 or less: ············ 35
3.1.8 Data in remote registers ······································································ 36
(1) X-SEL remote I/O areas and remote register areas···································· 36
(2) Transmission and receipt of signals in remote I/O areas ····························· 37
(3) Transmission and receipt of signals in remote register areas ······················· 38
3.1.9 CSP file ··························································································· 43
3.2 Remote I/O station ································································ ················ · 44
3.2.1 Models ···························································································· 44