Electro Cam PL-1746 Series - Manual (Page 62)

4-17 PLS Functions
Model & Options
Backplane
PL-1746 Function Name SLC 500 Mapping Read/ Valid Range for Data
File Index Write
Address Number Capability
Model M0:S.0 128 R/O 1746
Options M0:S.2 132 R/O 0 = Standard, 1 = Shift Register
MAIN SCREEN to TEST MENU to SYSTEM INFO MENU to
MODEL & OPTIONS
PL-1746-C02/3-R1
OPTIONS:STD
Description This screen displays the model type and the options included (designated by letters).
Motion ANDing
Backplane
PL-1746 Function Name SLC 500 Mapping Read/ Valid Range for Data
File Index Write
Address Number Capability
Motion ANDing M0:S.512- 1152- R/W* 0=OFF
Channels 0-31, 1word/channel M0:S.543 1214 Not while 1=ML1
running 2=ML2
Screen MAIN SCREEN to CONFIG MENU to INITIAL SETUP to MO-
TION ANDING
CHN: 12
MOTION AND: L1 Channel number
Motion ANDing level: L1, L2, or OFF.
(Toggle with SEL key)
This screen displays the channel number and the motion ANDing limit band for Motion
ANDing: L1, L2, or OFF. The channel will not be Motion ANDed if the enable is OFF.
Select a new channel by pressing the INC/DEC keys, or through direct numeric entry
followed by ENT. Press the SEL key to toggle the ANDing to L1, L2, or OFF.
Description This function is used to tie the operation of output channels to the motion detection
levels programmed through MOTION ANDING LIMIT BANDS. Each output channel
may be ANDed with either motion ANDing limit band. If an output is Motion ANDed, it
will turn ON only when the resolver RPM is in the range band specified for that motion
ANDing limit band, AND the setpoints progammed for that channel are ON.
Operation
• Any number of output channels can be ANDed to a single Motion Detection level.
• Motion ANDing and Output Enable ANDing can be combined for any given output
channel.
• When Motion ANDing is activated for a channel, it will apply to that channel in all
programs.
Motion Detector
An output channel can be used as a motion detector by programming it to be on at “1”
and off at “1,” and then ANDing it with the desired Motion Level. This will turn the output
on constantly as long as the machine speed is within the specified Motion Level range.
Outputs that must always operate, regardless of machine speed, should not be ANDed
with a motion ANDing limit band. Also see MOTION DETECTION.