2 linking two main stations with fiber – Clear-Com HLI-FBS User Manual
Page 94
8.1.2
Linking two Main Stations with Fiber
1)
Insert an HLI-FBS Fiber interface module in each station. Use any of the three slots
available.
Note:
Ensure that the Main Station is powered down before inserting
modules.
2)
Ensure that an SFP Transceiver is connected into one HLI-FBS module port on each
station.
3)
Connect Two Fibers from one HLI-FBS port on one station to one HLI-FBS port on
the other station. If using Single connector fiber, make sure that Tx on one goes to
Rx on the other.
4)
Power up both stations. Verify that the green LED on each HLI- FBS port is flashing.
5)
Go to Networking->Stations menu on each station. You should see two entries on
each screen indicating that each station properly sees itself and the other station.
6)
Go to Networking->Linking->Link Station menu on each station and select
Enabled. You now have an 8 channels system and can start assigning channels to
Main Stations and Beltpacks.
Note:
You should see a Link icon
on the Main Station display.
Figure 8-2: Linking two stations with Fiber
HLI-FBS
HLI-FBS
94
HelixNet Partyline User Guide