Clear-Com HLI-FBS - Manual (Page 59)

9) If you are setting up a continuous audio (program) feed using the four-wire interface
module, then you may want to enable the VOX functionality. To help reduce
redundant noise, the VOX functionality automatically deactivates and activates the
continuous audio feed, at an automatically determined volume threshold.
Note: If you assign a program and a four-wire interface to the same channel, VOX
is automatically enabled.
To enable or disable VOX:
a) From the third menu, select VOX.
b) From the fourth menu, select one of the following:
• Enabled.
• Disabled (default)
c) To confirm the selected setting, press the rotary control.
10) The VOX Delay OFF setting determines the length of time to wait before deactivating
the incoming audio. To set the VOX Delay OFF setting:
a) From the third menu, select VOX Delay OFF.
b) From the fourth menu, select one of the following:
• .5 sec (default)
• 1 sec
• 2 sec
• 3 sec
• 4 sec
c) To confirm the selected setting, press the rotary control.
4.6.2 Configuring a Two-wire interface module
The following procedure shows you how to configure the Module Settings for a Two-wire
interface module.
Note: The Two-wire interface module must receive power from the partyline.
To configure the Module Settings for a Two-wire interface module:
1) In Menu mode, select Module Settings.
59 HelixNet Partyline User Guide