Clear-Com HLI-FBS - Manual (Page 103)

9.1.2 Ethernet point-to-point link
Remote and Speaker Stations have RJ45 Ethernet connectors and can connect to Main
Stations over Ethernet.
1) Insert an HLI-ET2 Ethernet interface module in the Main Station. Use any of the three
slots available.
Note: Ensure that the Main Station is powered down before inserting
modules.
2) Connect a regular Ethernet cable (for example, CAT5, CAT5e, CAT6, CAT6e) from
one HLI-ET2 port on one station to the Remote or Speaker Station.
3) Connect an external AC/DC power adapter to the Remote or Speaker Station
4) Power up both Stations. Verify that the green LEDs on the HLI-ET2 port and on the
Remote or Speaker Station are on.
5) Go to Networking->Pair to Station->By Name on the Remote or Speaker Station.
You should see one entry indicating that the Remote or Speaker Station has properly
detected the Main Station. Select this entry.
6) Go to Station Settings->Keyset Assign and assign channels to any keyset.
HRM-4X (with Power Supply)
Cat5 cable
HLI-ET2
HMS-4X
Line 2
Line 1
HKB-2X (with Power Supply)
Cat5 cable
HLI-ET2
HMS-4X
Line 2
Line 1
103 HelixNet Partyline User Guide