1 linking two main stations with ethernet – Clear-Com HLI-FBS User Manual
Page 93
8.1.1
Linking two Main Stations with Ethernet
1)
Insert an HLI-ET2 Ethernet interface module in each station. Use any of the three
slots available.
Note:
Ensure that the Main Station is powered down before inserting
modules.
2)
Connect a regular Ethernet cable (for example, CAT5, CAT5e, CAT6, CAT6e) from
one HLI-ET2 port on one station to one HLI-ET2 port on the other station.
3)
Power up both stations. Verify that the green LED on each HLI-ET2 port is flashing.
4)
Go to Networking->Stations menu on each station. You should see two entries on
each screen indicating that each station properly sees itself and the other station.
5)
Go to Networking->Linking->Link Station menu on each station and select
Enabled. You now have an 8 channel system and can start assigning channels to
Main Stations and Beltpacks.
Note:
You should see a Link icon
on the Main Station display.
Figure 8-1: Linking two stations with Ethernet
HLI-ET2
HLI-ET2
Cat5 or Cat6
93
HelixNet Partyline User Guide