Clear-Com HLI-FBS - Manual (Page 104)

9.1.3 Local IP Network
1) Insert an HLI-ET2 Ethernet interface module into the Main Station. Use any of the
three slots available.
Note: Ensure that the Main Station is powered down before inserting
modules.
2) Connect a regular Ethernet cable (for example, CAT5, CAT5e, CAT6, CAT6e) from
one HLI-ET2 port to an Ethernet Switch and connect Remote or Speaker Stations to
Ethernet Switch as well.
3) Connect an external AC/DC power adapter to the Remote or Speaker Station or
connect them on a Power over Ethernet (PoE) port on the Ethernet Switch.
4) Power up all Stations. Verify that the green LED on the HLI-ET2 port and on the
Remote or Speaker Station is on.
5) Go to Networking->Link to Station->By Name on each Remote and Speaker
Station. You should see one entry indicating that the Remote or Speaker Station has
properly detected the Main Station. Select this entry.
6) Go to Station Settings->Keyset Assign and assign channels to any keyset.
HKB-2X
(with Power
Sypply)
HKB-2X (PoE)
HRM-4X (with Power Supply)
Ethernet Switch
HMS-4X
Line 2
Line 1
HRM-4X (PoE)
Ethernet Switch (PoE)
104 HelixNet Partyline User Guide