Clear-Com HLI-FBS - Manual (Page 65)

d) From the fourth display screen, edit the gateway.
Note: You can only edit the gateway if DHCP is disabled.
6) To edit the Subnet Mask:
a) In Menu mode, select Networking.
Note: The Networking menu only appears if an Ethernet or Fiber interface module
is detected.
b) From the second menu, select Preferences.
c) From the third menu, select Subnet Mask.
d) From the fourth display screen, edit the Subnet Mask.
Note: You can only edit the Subnet Mask if DHCP is disabled.
4.6.4 Configuring the Module Settings: Version information
The software (firmware) for the ports on the interface module must match that on the HelixNet
Main Station itself.
Note: Ethernet and fiber option modules do not contain software.
To check the software version for the Main Station and each port on the interface module:
1) In Menu mode, select Administration > Software > Current.
2) In the fourth menu, use the rotary control to scroll the displayed software versions.
3) The software versions for each port are listed under Snx, where n indicates the slot
number, and x indicates port A or port B.
The software versions for the two processors in the Main Station (Main Station and
IV-Router) are listed under MS and IVR respectively.
4.7 Administration
In Menu mode > Administration, you can:
• View the current versions of the software for the system.
• Update the software (firmware).
• Lock or unlock the menus on HBP-2X beltpacks, Remote Stations and Speaker
Stations connected to the main station.
• Reset the Main Station to the default settings.
• Manually reboot the Main Station.
• Save and Restore the settings.
4.7.1 Viewing the current versions of the software
To view the current versions of the software on the Main Station, see 4.6.4 Configuring the
Module Settings: Version information.
65 HelixNet Partyline User Guide