Clear-Com HLI-FBS - Manual (Page 41)

3.3.1 Speaker Station in an S-Mount bracket
Figure 3-3 Speaker Station in S-Mount bracket
You can adjust the S-Mount bracket by pressing one of the release buttons on either side of
the bracket. You can adjust the bracket in 10-degree steps from 80 degrees to horizontal.
Indicators are present beside the release buttons that show the adjustment steps.
To install the Speaker Station:
1) Connect a powerline XLR-3 port on the Speaker Station to a powerline XLR-3 port on
a Main Station.
Or
Connect an Ethernet port on the Speaker Station to an Ethernet port on an HMS-4X
HLI-ET2 option module.
2) Connect a headset or microphone to the Speaker Station.
3) Connect power supply to the DC power port on the Speaker Station. (Not necessary
if using Powerline or PoE.)
3.3.2 Speaker Station in an S-Mount bracket wall installation
When the Speaker Station is fully closed, you can mount it on a wall using the rear keyholes:
1) Space the wall screws to match the distance between the rear keyholes. See Figure
3-4.
2) If necessary, remove the Speaker Station from the S-Mount bracket.
41 HelixNet Partyline User Guide