Clear-Com HLI-FBS - Manual (Page 63)

a) From the third menu, select VOX.
b) From the fourth menu, select one of the following:
• Enabled
• Disabled (default)
c) To confirm the selected setting, press the rotary control.
12) The VOX Delay OFF setting determines the length of time to wait before deactivating
the incoming audio. To set the VOX Delay OFF setting:
a) From the third menu, select VOX Delay OFF.
b) From the fourth menu, select one of the following:
• .5 sec (default)
• 1 sec
• 2 sec
• 3 sec
• 4 sec
c) To confirm the selected setting, press the rotary control.
4.6.3 Configuring an Ethernet or Fiber interface module
The following procedure shows you how to configure the Module Settings for an Ethernet
interface module.
To configure the Module Settings for an Ethernet interface module:
1) To view status information about Main Stations:
a) In Menu mode, select Networking.
Note: The Networking menu only appears if at least one Ethernet or Fiber interface
module is detected.
b) From the second menu, select Stations. A list of station IDs is given for each
Main Station in the network. Each station ID in the list is preceded by the
letter L- for the Local station itself and R- for all remote stations.
c) From the third menu select the required station ID.
d) From the fourth menu you can view the following:
• Status – Enabled or Disabled
• IP – The IP address.
2) To enable or disable linking:
a) In Menu mode, select Networking.
Note: The Networking menu only appears if an Ethernet or Fiber interface module
is detected.
b) From the second menu, select Linking.
63 HelixNet Partyline User Guide