Clear-Com HLI-FBS - Manual (Page 101)

9 Linking Remote Stations and Speaker Stations
This chapter describes how to pair Remote and Speaker Stations to Main Stations. You can
connect Remote and Speaker Stations on one of the Digital Intercom Lines, point-to-point to a
Main Station Ethernet interface module (HLI-ET2) or over an IP network.
Pairing to a Main Station over an IP network requires an Ethernet interface module fitted to
the extension bay of the Main Station (HLI-ET2).
Note: If you change the network topology between any two stations, you must reboot the stations.
Note: If the IP address on a Remote Station or Speaker Station changes, you must either reboot the
Remote Station or disable and then re-enable the DHCP on the Remote Station.
Warning: . Digital intercom lines and the Ethernet connections are mutually
exclusive on Remote and Speaker Stations. If both are connected it will be
detected as a fault, communication over both ports will stop and both status
LEDs will blink RED. This requires a reboot of the station using
Administration > Reset > Reboot
Warning: When changing the connection from digital intercom line to
Ethernet or vice-versa, you must disconnect one cable and then wait until
the unit has detected a loss of connection before connecting the other
cable. Otherwise, they will briefly be detected as both connected.
Warning: When changing the power connections to a Remote Station, a
network storm error message may appear. If so, disconnect the power
cable, and reboot the Remote Station.
101 HelixNet Partyline User Guide