Clear-Com HLI-FBS - Manual (Page 66)

4.7.2 Updating the software
Any HBP-2X beltpacks, Remote Stations and Speaker Stations that are connected to the Main
Station are automatically updated. The units remain non-functional for approximately 5
minutes while they are updated.
To update the software:
1) After downloading the software update, copy the update to a USB memory stick.
2) Insert the memory stick into the USB 2.0 (A) connector. See Table 2-3 Key to Main
Station/Remote Station front panel diagram.
3) In Menu mode, select Administration and then Software.
4) From the third menu, select Update.
5) The fourth menu displays the new software version information on the USB memory
stick. To start updating the Main Station with the new software, press the rotary
control.
The process of updating the software takes several minutes. The following system messages
are displayed during the process:
Loading image
Erasing flash
Writing to flash
Verifying flash
Successful
66 HelixNet Partyline User Guide