Clear-Com HLI-FBS - Manual (Page 105)

9.1.4 Remote IP Network
Remote and Speaker Stations can connect to a Main Station that is not within the same
network Broadcast Domain.
1) Insert an HLI-ET2 Ethernet interface module in the Main Station. Use any of the three
slots available.
Note: Ensure that the Main Station is powered down before inserting
modules.
2) Connect a regular Ethernet cable (for example, CAT5, CAT5e, CAT6, CAT6e) from
one HLI-ET2 port to a Router/Gateway. Make sure you know the Gateway IP address
for that first subnet.
3) Connect Remote or Speaker Stations to a Router/Gateway. Make sure you know the
Gateway IP address for that second subnet.
4) Connect an external AC/DC power adapter to the Remote or Speaker Station or
connect them on a Power over Ethernet (PoE) port on the Ethernet Switch.
5) Power up all Stations. Verify that the green LED on the HLI-ET2 port and on the
Remote or Speaker Station is on.
6) On the Main Station, go to Networking->Preferences->IP Address and note the IP
address of the Main Station. Make sure that Networking->Preferences->Gateway
and Networking->Preferences->Netmask match that of your subnet.
7) On each Remote and Speaker Station make sure that all Networking->Preferences
match that of your subnet.
8) On each Remote and Speaker Station go to Networking->Link to Station->By
Address and enter the IP address of the Main Station.
9) Go to Station Settings->Keyset Assign and assign channels to any keyset.
105 HelixNet Partyline User Guide