3 setting the screensaver, 6 administration, 1 viewing the ip address – Clear-Com HLI-FBS User Manual
Page 90: Administration
7.5.3
Setting the screensaver
The screensaver is displayed on screen after 10 minutes of inactivity on the beltpack. To
enable (or disable) the screensaver:
1)
In Menu mode, press the left-hand Call Key and then select Display Settings.
2)
Select Screensaver.
3)
Select one of the following:
• Enabled (default)
• Disabled
4)
To confirm the selected setting, press the right-hand Call key.
7.6
Administration
In Menu mode > Administration, you can:
• View the IP address for the network.
• View the current version of the software on the beltpack.
• Reset the beltpack to default (factory mode) settings.
The beltpacks receive updated (default) channel label information. Other local beltpack
settings will not be reset if the Main Station is reset to default settings.
7.6.1
Viewing the IP address
To view the IP address for the network:
1)
In Menu mode, press the left-hand Call Key and then select Administration.
2)
Select IP Address.
3)
The IP address for the network is displayed. The IP address appears similar to the
following example:
10.0.0.1
To view the current version of the software on the beltpack:
1)
In Menu mode, press the left-hand Call Key and then select Administration.
2)
Select Software Version.
3)
The current version of the software is displayed. The software version information will
appear similar to the following example:
npl-x.x.xx.xxxx, uboot
Where x is a numerical value.
90
HelixNet Partyline User Guide