Clear-Com HLI-FBS - Manual (Page 91)

7.6.2 Resetting the beltpack to default (factory mode) settings
To reset the beltpack to default (factory mode) settings:
1) In Menu mode, press the left-hand Call Key and then select Administration.
2) Select Reset to Default.
3) Reset Now is displayed (shown as selected). To reset the beltpack, press the right-
hand Call key.
7.7 Diagnostics
The Diagnostics menus help you to monitor the performance of the beltpack and diagnose
possible system issues.
7.7.1 Viewing information about the hardware (main PCB) on the beltpack
To view information about the Part, Revision and Serial number of the main PCB on the
beltpack:
1) In Menu mode, press the left-hand Call Key and then select Diagnostics.
2) Select Hardware > Main PCB.
The Part, Revision and Serial number for the PCB are displayed. The format is
similar to the following:
Part xxxxxxx
Revision: x
Serial: x
Where x is a numerical value.
7.7.2 Viewing powerline information and status
To view powerline information and status:
1) In Menu mode, press the left-hand Call Key and then select Diagnostics.
2) Select Powerline.
The status and other powerline information are displayed. For more information, see
16 Menu maps.
91 HelixNet Partyline User Guide