Clear-Com HLI-FBS - Manual (Page 79)

5) The fourth menu displays the new software version information on the USB memory
stick. To start updating the Main Station with the new software, press the rotary
control.
The process of updating the software takes several minutes. The following system messages
are displayed during the process:
Loading image
Erasing flash
Writing to flash
Verifying flash
Successful
Do not turn off the power to the Remote Station during the software
(firmware) update. Turning off the power can damage the device.
Note: Do not remove the USB memory stick from the Main Station or Remote Station until the
software update is completed.
Note: The Remote Station resets automatically. You are not required to restart the Remote
Station. To check that the software upgrade was performed successfully, see 5.6.1 Viewing
the current versions of the software.
5.6.3 Resetting the Remote Station to default settings.
To reset the Remote Station to its default (factory mode) settings:
1) In Menu mode, select Administration and then Reset.
2) The third menu displays a selected menu item: Reset to Default.
3) In the fourth menu, select Reset Now.
5.6.4 Manually rebooting the Remote Station
To manually reboot the Remote Station:
1) In Menu mode, select Administration and then Reset.
2) The third menu select Reboot.
3) In the fourth menu, select Reboot Now.
When the rotary control is pressed, the display changes to Rebooting … for 2 seconds, and
then the Remote Station reboots.
79 HelixNet Partyline User Guide