Clear-Com HLI-FBS - Manual (Page 43)

3.4 Installing the HBP-2X Beltpacks
The HBP-2X Beltpack is a device that you can:
• Wear at your belt using the beltclip.
• Install to a shelf or other flat surface.
• Attach to a pole or other fixed upright position.
For more information, see 2.5.3 HBP-2X beltclip, beltloops and feet (base view)
3.4.1 Power up
The HBP-2X Beltpack is powered from the standard mic cable that connects the device with
the HMS-4X Main Station (see below).
3.4.2 Connecting the HBP-2X Beltpack to the Main Station
To connect the HBP-2X Beltpack to the Main Station:
1) There are two partylines on the Main Station which can each support up to 10 digital
HBP-2X beltpacks. There are two connectors (3-pin XLR, male and female) for each
line.
Connect the cable to the selected connector on the Main Station.
Note: For the location of Lines 1 and 2 (the powerlines) on the Main Station, see
F G
in Figure 2-3: HMS-4X Main Station: rear panel
2) Connect the cable to the beltpack, using one of the two 3-pin XLR connectors (male
and female) on the base / rear of the beltpack.
For example topologies, see 3.1.2 Topologies.
43 HelixNet Partyline User Guide