Alamo HYDRO 15 - Manual (Page 6)

HYDRO 15 (Service Manual) 09/06
© 2006 Alamo Group Inc.
Index -2
Section Page
Section 1 - Specifications...........................................................................1-1 to 1-7
Do Not Do or Allow Items (Read First Thing).......................... 1-2
Mower Specifications...........................................................1-3 to 1-5
Bolt Torque Specifications Chart........................................... 1-5
Pump & Motor Hydraulic Schematic - 15 Foot Model..............1-6
Pump & Motor Hydraulic Schematic - 10 Foot Model..............1-7
Section 2 - Pump Service & Repair.......................................................... 2-1 to 2- 22
Pump Repair Preparation Procedures...................................2-2
Pump Test Procedure.......................................................... 2-3 to 2-4
Pump & Motor Hydraulic Schematic - 15 Foot Model..............2-5
Pump & Motor Hydraulic Schematic - 10 Foot Model..............2-6
Recommended & Required Tools.......................................... 2-7
Pump Cleaning & Removal................................................... 2-8
Pump Component Identification............................................ 2-9
Pump Dis-Assembly Preparations........................................ 2-10
Pump Dis-Assembly Procedures.......................................... 2-11 to 2-13
Pump Component Wear Inspection Guide............................. 2-14
Pump Assembly Preparation................................................ 2-15
Pump Assembly Procedures................................................ 2-16 to 2-21
Pump Recommended Start Up Procedure............................. 2-22
Section 3 - Motor Service & Repair.......................................................... 3-1 to 3-25
Motor Repair Preparation Procedures................................... 3-2
Motor Test Procedure.......................................................... 3-3 to 3-4
Motor & Pump Hydraulic Schematic - 15 Foot Model..............3-5
Motor & Pump Hydraulic Schematic - 10 Foot Model..............3-6
Recommended & Required Tools.......................................... 3-7
Motor Cleaning & Removal................................................... 3-8
Motor Identification Center & Wings...................................... 3-8 to 3-9
Motor Dis-Assembly Preparation (Center).............................. 3-10
Motor Dis-Assembly Preparation (Wings).............................. 3-11
Motor Component Identification.............................................3-12
Motor Dis-Assembly Procedures.......................................... 3-12 to 3-15
Motor Component Wear Inspection Guide..............................3-16
Motor Assembly Preparation................................................ 3-17
Motor Assembly Procedures................................................ 3-17 to 3-23
Motor Recommended Start Up Procedure..............................3-24
Motor Electrical System (wing Motors).................................. 3-24 to 3-25
Section 4 - Spindle Repair......................................................................... 4-1 to 4-10
Spindle Component Identification.......................................... 4-2
Blade Carrier Removal..........................................................4-9 TO 4-10
Spindle Removal Preparation................................................ 4-2
Spindle Housing Removal.....................................................4-2 to 4-3
Spindle Housing Dis-Assembly.............................................4-3 to 4-5
Spindle Component Inspection Part Condition........................ 4-5
Spindle Assembly Procedure............................................... 4-5 to 4-9
Blade Carrier Installation...................................................... 4-9 to 4-10
INDEX