ACU-RITE MILLPWR Old Style - Manual (Page 93)

PROGRAM STEPS
MILLPWR
Page 5-16
Operation Manual
Mirror
You can make a mirror image of any section of your
program using this step. Enter the
RANGE of steps you want
to mirror, and the end points of the “mirror line,” called the
axis of reflection. The axis does not have to be vertical or
horizontal; you can use any line.
Example:
To make a “left handed” part 2 inches away, put a
vertical axis 1 inch to the left of the original part.
MIRROR 005
1ST AXIS POINT
X1 ABS
Y1 ABS
STEP RANGE
FIRST
LAST
2ND AXIS POINT
X2 ABS
Y2 ABS
001 MILL LINE
002 MILL LINE
003 MILL LINE
004 POSITION/DRILL
MIRROR 005
1ST AXIS POINT
-1.000 X ABS
0.000 Y ABS
STEP RANGE
001 FIRST
004 LAST
2ND AXIS POINT
-1.000 X ABS
1.000 Y ABS
1.0
2.0
ORIGINAL
STEPS 001 THRU 004
AXIS OF
REFLECTION
LEFT HAND PART
The axis line
doesn’t have to be
very long--this one
is only 1”.