ACU-RITE MILLPWR Old Style - Manual (Page 40)

PROGRAMMING
MILLPWR
Operation Manual
Page 3-15
subdirectory under JULY1998, layer another one under that, one under that and so
on. How many directories you create and how you layer them is up to you.
Follow the steps below to create directories for your own programs.
•
After you have selected the PROGRAM FUNCTIONS and DIRECTORY options,
press the SELECT DIRECTORY softkey.
SERVO OFF FEED 0 100% INCH SCALE 1.0000 TOOL:
SELECT
DIRECTORY
PAGE
UP
PAGE
DOWN
REMOTE
STORAGE
SELECT A WORKING DIRECTORY.
USE
FLOPPY
CURRENT PROGRAM
END OF 11
001 SET TOOL
002 MILL ARC
003 MILL LINE
004 MILL LINE
005 MILL LINE
006 BLEND
007 MILL LINE
008 MILL LINE
009 MILL LINE
010 SET TOOL
011 BOLT CIRCLE
DIRECTORY
MILLPWR
1 OF 5
JULY1998
COMPANY2
COMPANY1
COMPANY3
•
Indicate where you want to store your new subdirectory.
On MILLPWR ’s internal hard disk drive:
Check that the USE FLOPPY and REMOTE STORAGE softkeys are not
selected. “MILLPWR” and any subdirectories should appear under the
“Directory” heading.
On a 3 ½” floppy disk:
Press the USE FLOPPY softkey. “A:” and any subdirectories should
appear under the “Directory” heading.
On your PC’s hard disk drive:
Press the REMOTE STORAGE softkey. “REMTSTOR” and any
subdirectories should appear under the “Directory” heading.