ACU-RITE MILLPWR Old Style - Manual (Page 113)

SETUP
MILLPWR
Page 7-2
Operation Manual
Operator Setup
Tool Library
A list of tools is available to you for convenient selection during programming and/or
operation of the MILLPWR . There are 99 “slots” in the Tool Library. You can
organize tools any way you wish. One way is to keep all your flat end mills together
in a group, all drills in a group, and so on. Another way is to group them by size.
Move to TOOL LIBRARY , and press ENTER .
To add a tool to the tool library, select an unused slot and press ENTER . Fill in the
DIAMETER , the UNITS , and the TYPE (press the TOOL TYPES softkey to see the
available list). Press USE to enter the tool into the library.
To change an existing tool, move to that tool and press ENTER . Make any changes and
press USE . The changed tool will now appear in the library.
You can see the library in numerical order, or, if you press the SORT BY TYPE softkey,
by tool type.
Put your most
commonly used
tools first!
SERVO OFF FEED 0 100% INCH SCALE 1.0000 TOOL:
SORT BY
NUMBER SORT BY
TYPE
CANCEL
CHANGES
USE NEW
SETTINGS
TOOL LIBRARY
1 OF 99
1
2
3
4
5
6
7
8
DRILL INCH 0.0625 9
DRILL INCH 0.1250 10
DRILL INCH 0.3875 11
DRILL INCH 0.5000 12
13
14