ACU-RITE MILLPWR Old Style - Manual (Page 87)

PROGRAM STEPS
MILLPWR
Page 5-10
Operation Manual
Ring
A ring is actually a circular pocket with a circular island in the
center.
Enter the CENTER position, the radius of the pocket
( OUTSIDE RADIUS ), and the radius of the island ( INSIDE
RADIUS ).
The DIRECTION of cut on the inside radius will determine
whether you are climb milling or conventional milling.
MILLPWR will reverse the tool movement direction on the
outside radius so the milling direction stays the same.
The MORE softkey brings up the FINISH CUT entry field.
RING 001
DEPTH
0.0000 Z ABS
DIRECTION
CCW
CENTER
X ABS
Y ABS
TOOL
INCH
TYPE
10 FEED IPM
RADIUS
OUTSIDE
INSIDE
RAD 1
Z DEPTH
FINISH
ALLOWANCE
RAD 2
FINISH
0.0000 CUT
0 FEED IPM
STEPOVR % 80
DIR CCW