ACU-RITE MILLPWR Old Style - Manual (Page 42)

PROGRAMMING
MILLPWR
Operation Manual
Page 3-17
Selecting a Directory
The SELECT DIRECTORY softkey allows you to open any of the established
directories on MILLPWR ’s internal hard disk drive, on a 3 ½” floppy disk, or on
your PC’s hard disk drive—whichever one you’ve chosen. You will use this feature
anytime you save or load a program.
•
After you have selected the PROGRAM FUNCTIONS and DIRECTORY options,
press the SELECT DIRECTORY softkey. The last directory that was opened will
appear.
SERVO OFF FEED 0 100% INCH SCALE 1.0000 TOOL:
SELECT
DIRECTORY
PAGE
UP
PAGE
D O W N
REMOTE
STORAGE
SELECT A WORKING DIRECTORY.
USE
FLOPPY
CURRENT PROGRAM
END OF 11
001 SET TOOL
002 MILL ARC
003 MILL LINE
004 MILL LINE
005 MILL LINE
006 BLEND
007 MILL LINE
008 MILL LINE
009 MILL LINE
010 SET TOOL
011 BOLT CIRCLE
DIRECTORY
MILLPWR
1 OF 5
JULY1998
COMPANY2
COMPANY1
COMPANY3
•
Indicate where the directory you want to select is located.
On MILLPWR ’s internal hard disk drive:
Check that the USE FLOPPY and REMOTE STORAGE softkeys are not
selected. “MILLPWR” and any subdirectories you have created should
appear under the “Directory” heading.
On a 3 ½” floppy disk:
Insert the 3 ½” floppy disk containing the directory into the disk drive
(located in the upper-left corner on the front of the
MILLPWR operator
console) and press the USE FLOPPY softkey. “A:” and any