ACU-RITE MILLPWR Old Style - Manual (Page 132)

TROUBLESHOOTING GUIDE
MILLPWR
Operation Manual
Page 9-5
Symptom Problem Recommendation
Table Run Away (cont.)
X and/or Y Axis Linear Encoders
Stopped Counting (cont.)
Should the linear encoder count in
certain areas only, contact your
ACU-RITE MILLPWR
representative
Should the above recom-
mendation not correct the problem,
contact your ACU-RITE
MILLPWR representative for
repair or replacement procedures.
Improper Tachometer Wire Con-
nections
Contact your ACU-RITE
MILLPWR representative for
repair or replacement procedures.
No Signal. The motor will turn
very slowly and always in one
direction.
Contact your ACU-RITE
MILLPWR representative for
repair or replacement proce-
dures.
Table Has Stiff Movement
Table is Locked
Ensure that the table is not locked.
Gibs Out of Adjustment
Refer to the machine tool manual.
No Oil in Oil Reservoir or Oil
Lines are Blocked or Discon-
nected.
Check that there is sufficient oil in
the oil reservoir.
Should the above recom-
mendation not correct the
applicable problem, contact your
ACU-RITE MILLPWR
representative for repair or
replacement procedures.
System Not Repeating or Circles
Out of Round
Machine Tool Related Problems
Ensure that the knee, ram, head
bolts, turret to column bolts and
head to knuckle bolts are properly
secured.
Check the gib adjustments (refer to
the machine tool manual).