ACU-RITE MILLPWR Old Style - Manual (Page 44)

PROGRAMMING
MILLPWR
Operation Manual
Page 3-19
Deleting a Directory
Note: MILLPWR will not delete directories that contain programs. You must delete
each program stored within the directory before continuing. Refer to the Deleting a
Program section.
To delete an empty directory:
•
After you have selected the PROGRAM FUNCTIONS and DIRECTORY options,
press the DELETE DIRECTORY softkey.
•
Identify where the directory you want to delete is located.
On MILLPWR ’s internal hard disk drive:
Check that the USE FLOPPY and REMOTE STORAGE softkeys are not
selected. “MILLPWR” and any subdirectories you have created should
appear under the “Directory” heading.
On a 3 ½” floppy disk:
Insert the 3 ½” floppy disk containing the directory into the disk drive
(located in the upper-left corner on the front of the
MILLPWR operator
console) and press the USE FLOPPY softkey. “A:” and any
subdirectories you have created will appear under the “Directory”
heading.
On your PC:
Press the REMOTE STORAGE softkey. “REMTSTOR” and any
subdirectories you have created will appear under the “Directory”
heading.
•
Using the arrow keys, highlight the directory you want to delete.
•
Press the ENTER key. You will be asked if you are sure that you want to delete
the program. Press the “Yes” softkey to continue or the “No” softkey to cancel
the operation.