ACU-RITE MILLPWR Old Style - Manual (Page 120)

SETUP
MILLPWR
Operation Manual
Page 7-9
Serial Port
After you have created a part program, you can store it any of three ways: on
MILLPWR ’s internal hard disk drive, on a 3 ½” floppy disk, or on the hard disk drive
of your PC using MILLPWR ’s serial port. Storing programs on your PC is often a good
idea, because doing so frees up MILLPWR ’s hard disk drive space, allowing
MILLPWR to perform faster.
Before you save a program on your PC using MILLPWR ’s serial port, you’ll need to
configure the parameters for the serial port. To do so, follow these simple steps:
•
Using the arrow keys, highlight SERIAL PORT and press the ENTER key.
•
Press the REMOTE STORAGE softkey to change the FUNCTION setting from “OFF”
to “REMOTE STORAGE.”
SERVO OFF FEED 0 100% INCH SCALE 1.0000 TOOL:
OFF
REMOTE
STORAGE
CANCEL
CHANGES
USE NEW
SETTINGS
SYSTEM SETUP
4 OF 4
PROTECTION
ERROR COMPENSATION
ENCODER DIRECTION
SERIAL PORT
SERIAL PORT
FUNCTION
BAUD RATE
OFF
9600
SERIAL PORT
FUNCTION
REMOTE STORAGE
BAUD RATE
9600