beautypg.com

Planet Technology WGSW-48040 User Manual

Page 97

background image

User’s Manual of WGSW-24020/WGSW-48040

-97-

Default Spanning-Tree Configuration

Feature

Default Value

Enable state

STP enabled for all ports

Port priority

128

Port cost

19

Bridge Priority

32,768

User-Changeable STA Parameters

The Switch’s factory default setting should cover the majority of installations. However, it is advisable to keep the default settings

as set at the factory; unless, it is absolutely necessary. The user changeable parameters in the Switch are as follows:

Priority

– A Priority for the switch can be set from 0 to 65535. 0 is equal to the highest Priority.

Hello Time

– The Hello Time can be from 1 to 10 seconds. This is the interval between two transmissions of BPDU packets sent

by the Root Bridge to tell all other Switches that it is indeed the Root Bridge. If you set a Hello Time for your Switch, and it is not

the Root Bridge, the set Hello Time will be used if and when your Switch becomes the Root Bridge.

#

Notice

The Hello Time cannot be longer than the Max. Age. Otherwise, a configuration error will occur.

Max. Age

– The Max Age can be from 6 to 40 seconds. At the end of the Max Age, if a BPDU has still not been received from

the Root Bridge, your Switch will start sending its own BPDU to all other Switches for permission to become the Root Bridge. If it

turns out that your Switch has the lowest Bridge Identifier, it will become the Root Bridge.

Forward Delay Timer

– The Forward Delay can be from 4 to 30 seconds. This is the time any port on the

Switch spends in the listening state while moving from the blocking state to the forwarding state.

#

Notice

Observe the following formulas when setting the above parameters:

Max. Age _ 2 x (Forward Delay - 1 second)
Max. Age _ 2 x (Hello Time + 1 second)

Port Priority

– A Port Priority can be from 0 to 255. The lower the number, the greater the probability the port will be chosen as

the Root Port.

Port Cost

– A Port Cost can be set from 0 to 65535. The lower the number, the greater the probability the port will be chosen to

forward packets.

3. Illustration of STP

A simple illustration of three switches connected in a loop is depicted in Figure 5-7. In this example, you can anticipate some

major network problems if the STP assistance is not applied. If switch A broadcasts a packet to switch B, switch B will broadcast

it to switch C, and switch C will broadcast it to back to switch A ... and so on. The broadcast packet will be passed indefinitely in

a loop, potentially causing a network failure. In this example, STP breaks the loop by blocking the connection between switch B

and C. The decision to block a particular connection is based on the STP calculation of the most current Bridge and Port

settings. Now, if switch A broadcasts a packet to switch C, then switch C will drop the packet at port 2 and the broadcast will end

there. Setting-up STP using values other than the defaults, can be complex. Therefore, you are advised to keep the default

factory settings and STP will automatically assign root bridges/ports and block loop connections. Influencing STP to choose a

particular switch as the root bridge using the Priority setting, or influencing STP to choose a particular port to block using the

This manual is related to the following products: