12 spanning-tree pathcost method, 13 spanning-tree bpdu, 2 spanning-tree bpdu – Planet Technology WGSW-48040 User Manual
Page 291: Syntax, Default configuration, Command mode, User guidelines, Example
User’s Manual of WGSW-24020/WGSW-48040
-29
5.21.12 spanning-tree pathcost method
The spanning-tree pathcost method command sets the default path cost method. To revert to the default setting, use the no
form of this command.
Syntax
spanning-tree pathcost method
{long | short}
no spanning-tree pathcost method
long — Specifies 1 through 200,000,000 range for port path costs.
short — Specifies 1 through 200,000,000 range for port path costs.
Default Configuration
Auto
Command Mode
Global configuration mode
User Guidelines
This command applies to all the spanning tree instances on the switch.
The priority value must be a multiple of 4096.
The cost is set using the spanning-tree cost command.
Example
The following example sets the default path cost method to "long".
Console# spanning-tree pathcost method long
5.21.13 spanning-tree bpdu
The spanning-tree bpdu global configuration command defines BPDU handling when spanning-tree is disabled on an
interface.
Syntax
spanning-tree bpdu
{filtering | flooding}
filtering — Filter BPDU packets when spanning-tree is disabled on an interface.
flooding — Flood BPDU packets when spanning-tree is disabled on an interface.
Default Configuration
The default definition is flooding.