11 port security, 12 port security routed secure-address, Command mode – Planet Technology WGSW-48040 User Manual
Page 166: User guidelines, Example, Syntax, Default configuration
User’s Manual of WGSW-24020/WGSW-48040
-16
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
In this example, the bridge tables are cleared.
console# clear bridge
5.4.11 port security
The port security interface configuration command locks the port. By locking the port, new addresses are not learned on the
port. To enable new address learning, use the no form of the port security command.
Syntax
port security
[forward | discard | discard-shutdown] [trap seconds]
no port security
forward — Forwards frames with unlearned source addresses, but does not learn the address.
discard — Discards frames with unlearned source addresses. This is the default if no option is indicated.
discard-shutdown — Discards frames with unlearned source addresses. The port is also shut down.
trap Seconds — Sends SNMP traps and defines the minimal amount of time in seconds between two consecutive traps.
(Range: 1 - 1,000,000)
Default Configuration
Disabled - No port security
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
In this example, frame forwarding is enabled without learning, and with traps sent every 100 seconds on port e18.
console (config)# interface ethernet e18
console (config-if)# port security forward trap 100
5.4.12 port security routed secure-address
The port security routed secure-address interface configuration command adds MAC-layer secure addresses to a routed