21 spanning-tree commands, 1 spanning-tree, 2 spanning-tree mode – Planet Technology WGSW-48040 User Manual
Page 284
User’s Manual of WGSW-24020/WGSW-48040
-28
5.21 Spanning-Tree Commands
5.21.1 spanning-tree
The spanning-tree global configuration command enables spanning-tree functionality. To disable spanning-tree functionality,
use the no form of this command.
Syntax
spanning-tree
no spanning-tree
Default Configuration
Spanning-tree is enabled.
Command Modes
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example enables spanning-tree functionality.
Console(config)# spanning-tree
5.21.2 spanning-tree mode
The spanning-tree mode global configuration command configures the spanning-tree protocol. To return to the default
configuration, use the no form of this command.
Syntax
spanning-tree mode
{stp | rstp}
no spanning-tree mode
stp — STP is supported.
rstp — RSTP is supported.
Default Configuration
Spanning-tree protocol (STP) is supported.
Command Modes
Global Configuration mode