8 password, 9 enable password, Syntax – Planet Technology WGSW-48040 User Manual
Page 156: Default configuration, Command mode, User guidelines, Example
User’s Manual of WGSW-24020/WGSW-48040
-15
5.3.8 password
The password line configuration command specifies a password on a line. To remove the password, use the no form of this
command.
Syntax
password password
[encrypted]
no password
password — Password for this level, from 1 to 159 characters in length.
encrypted — Encrypted password to be entered, copied from another device configuration.
Default Configuration
This command has no default configuration.
Command Mode
Line Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example specifies a password "abc" on a line.
console (config-line) # password abc
5.3.9 enable password
The enable password global configuration command sets a local password to control access to normal and privilege levels. To
remove the password requirement, use the no form of this command.
Syntax
enable password
[level level] password [encrypted]
no enable password
[level level]
password — Password for this level, from 1 to 159 characters in length.
level level — Level for which the password applies. If not specified the level is 15 (Range: 1-15).
encrypted — Encrypted password entered, copied from another device configuration.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.