17 switchport general map protocols-group vlan, 18 ip internal-usage-vlan, Syntax – Planet Technology WGSW-48040 User Manual
Page 344: Default configuration, Command mode, User guidelines, Example
User’s Manual of WGSW-24020/WGSW-48040
-34
5.27.17 switchport general map protocols-group vlan
The switchport general map protocols-group vlan interface configuration command sets a protocol-based classification rule.
To delete a classification, use the no form of this command.
Syntax
switchport general map protocols-group group vlan vlan-id
no switchport general map protocols-group group
group — Group number as defined in the map protocol protocols-group command. (Range: 1 - 2147483647)
vlan-id — Define the VLAN ID in the classifying rule.
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example sets a protocol-based classification rule of protocol group 1 to VLAN 8.
Console (config)# interface ethernet e8
Console (config-if)# switchport general map protocols-group 1 vlan 8
5.27.18 ip internal-usage-vlan
The ip internal-usage-vlan interface configuration command reserves a VLAN as the internal usage VLAN of an interface. Use
the no form of this command to reset to default.
Syntax
ip internal-usage-vlan vlan-id
no ip internal-usage-vlan
vlan-id — VLAN ID of the internal usage VLAN.(Range: Valid VLAN)
Default Configuration
This command has no default configuration.