16 show interfaces description, 17 show interfaces counters, Syntax – Planet Technology WGSW-48040 User Manual
Page 201: Default configuration, Command modes, User guidelines, Example
User’s Manual of WGSW-24020/WGSW-48040
-20
5.7.16 show interfaces description
The show interfaces description user EXEC command displays the description for all configured interfaces.
Syntax
show interfaces description [ethernet interface
| port-channel port-channel-number| out-of-band--eth oobinterface]
Interface — Valid Ethernet port.
port-channel-number — A valid port-channel trunk index.
oob-interface — Out-of-band Ethernet port number.
Default Configuration
This command has no default configuration.
Command Modes
Privilege EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the description for the interface g1.
Console# show interfaces description ethernet g1
Port Description
------ --------------------
e1 Management_port
e2 R&D_port
e3 Finance_port
Ch Description
----- ------------------
1 Output
5.7.17 show interfaces counters
The show interfaces counters user EXEC command displays traffic seen by the physical interface.