Planet Technology WGSW-48040 - Manual (Page 36)

User’s Manual of WGSW-24020/WGSW-48040
-36-
4.3 Port Configuration
In this field, you can see these parts, such as port settings, Link aggregation, LACP.
4.3.1 Port settings
To use the port settings screen for setting up each of the switch’s ports. It shows these parts: port, description, admin status, link
status, speed, duplex, MDI/MDIX, Flow control, type, LAG, PVE (see Figure 4-9):
Figure 4-9 Switch Port Settings screen
The Port Settings screen contains the following fields:
Port Shows the port number. You can click on the Detail button of the appropriate port
(G1, G2) to use an SFP module, and the Detail button shows the Port
Configuration Detail screen, which include port, description, port type, admin
status, current port status ……
Description Click up the Detail button to make a brief description of the port.
Administrative Status When to choose the UP button, the port can be accessed normally, to choose the
Down button, the port will be taken offline.
Link Status Shows an active connection when you choose the UP button, there is no active
connection or the port has been taken offline by an Admiinistrator when you
choose the Down button.
Speed Shows the connection speed of the port and the speed can be configured only
when auto-negotiation is disabled on that port.
Duplex The port duplex mode, Full (transmission occurs in both directions
simultaneously) or Half (transmission occurs in only one direction at a time). This
mode can be configured only when auto-negotiation is disabled and port speed is
set to 10Mbps or 100Mbps. It cannot be configured on Link Aggregation
Groups (LAGs)
.
MDI/ MDIX Shows the MDI/MDIX status of the port. To use the MDI setting if the port is
connected to an end station. To use the MDIX setting if the port is connected to a
hub or another switch.
Flow control Shows the flow control status of the port. It is active when the port uses Full
Duplex Mode.