Planet Technology WGSW-48040 - Manual (Page 243)

User’s Manual of WGSW-24020/WGSW-48040
-24
Command Mode
User EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example shows how all port-channel information is displayed.
Console (config)# show interfaces port-channel
Channel Ports
------------ -----------------
ch1 Active: g2
ch2 Active: e3, e7 Inactive: g1
ch3 Active: e4, e8
5.16 Port Monitor Commands
5.16.1 port monitor
The port monitor interface configuration command starts a port monitoring session. To stop a port monitoring session, use the
no form of this command.
Syntax
port monitor src-interface [rx | tx]
no port monitor src-interface
ƒ src-interface — Valid Ethernet port or port-channel number.
ƒ rx — Monitors received packets only. If no option specified, monitors both rx and tx.
ƒ tx — Monitors transmitted packets only. If no option specified, monitors both rx and tx.
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration mode
User Guidelines
This command enables traffic on one port to be copied to another port, or between the source port (src-interface) and a
destination port (the port being configured). Only a single target port can be defined per system.
The port being monitored cannot be set faster than the monitoring port.