21 show ports storm-control, 1 show ports storm-control – Planet Technology WGSW-48040 User Manual
Page 206
User’s Manual of WGSW-24020/WGSW-48040
-20
Default Configuration
The default storm control broadcast rate is 12000.
Command Mode
Interface Configuration (Ethernet)
User Guidelines
Use the port storm-control broadcast enable interface configuration command to enable broadcast storm control.
The rate is rounded to the nearest 64 kbytes/sec (except 1 - 63 kbytes/sec, which is rounded to 64 bytes/sec).
Note that if the rate is 0, broadcast packets are not forwarded.
Example
The following example configures the maximum broadcast rate 100 kilobytes per second.
console(config)# interface ethernet g2
console(config-if)# port storm-control broadcast rate 100
5.7.21 show ports storm-control
The show ports storm-control privileged EXEC command displays the storm control configuration.
Syntax
show ports storm-control
[ethernet interface]
ethernet interface—A valid Ethernet port.
Default Configuration
This command has no default configuration.
Command Modes
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the storm control configuration.
Console# show ports storm-control
Port Broadcast Storm control [kbyes/sec]
----- -------------------------------------------------