Planet Technology WGSW-48040 - Manual (Page 186)

User’s Manual of WGSW-24020/WGSW-48040
-18
Xmodem Source for the file from a serial connection that uses the Xmodem protocol.
null Null destination for copies or files. A remote file can be copied to null to determine its
size.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
The location of a file system dictates the format of the source or destination URL.
The startup-config and the backup-config files cannot be copied to the running-config file.
The entire copying process may take several minutes and differs from protocol to protocol and from network to network.
Filenames cannot be a substring of "startup-config" or "running-config". e.g. the following filenames are not allowed: "s", "st",
"sta".
File download from a TFTP server may take a long time, and therefore fail, if there are many Quality of Service elements (ACLs,
policers, etc.) present. In this case, it is recommended to copy the TFTP file to the backup configuration file, and then copy the
backup file to the running / startup configuration file.
When using tftp to copy files, it is recommended to set the tftp server timeout to 10-20 second.
The device does not accept new commands while files are being copied; however, the user does not receive notification that the
device is busy copying, and will “ignore” the command. Note that this behavior occurs only at the session, which initiated the
copy command; response to activity on other management sessions will result in a delay, but will not be ignored.
When a file is copied to the running configuration file or to the startup configuration file, the data in the file is checked. If the
check fails, the file is not downloaded, and the user is notified of the error. However, the user should use caution when copying a
file from a TFTP server to the backup configuration file, because there is no check of data.An attempt to display the corrupted
backup configuration file (show backup) will result in information which is meaningless to the user (or even a blank row).
The device does not accept new commands while files are being copied; however, the user does not receive notification that the
device is busy copying, and will “ignore” the command. Note that this behavior occurs only at the session, which initiated the
copy command; response to activity on other management sessions will result in a delay, but will not be ignored.
Understanding Invalid Combinations of Source and Destination
Some invalid combinations of source and destination exist. Specifically, the following cannot be copied:
If the source file and destination file are the same file.
xmodem cannot be a destination. Can only be copied to image, boot and null.
tftp cannot be the source and destination on the same copy.
Copy Character Descriptions: