6 radius-server deadtime, Default configuration, Command mode – Planet Technology WGSW-48040 User Manual
Page 261: User guidelines, Example, Syntax
User’s Manual of WGSW-24020/WGSW-48040
-26
timeout — Specifies the timeout value in seconds. (Range: 1 - 30)
Default Configuration
The default value is 3 seconds.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example sets the interval for which a router waits for a server host to reply to 5 seconds.
Console (config)# radius-server timeout 5
5.18.6 radius-server deadtime
The radius-server deadtime global configuration command improves RADIUS response times when servers are unavailable.
The command is used to cause the unavailable servers to be skipped. To reset the default value, use the no form of this
command.
Syntax
radius-server deadtime deadtime
no radius-server deadtime
deadtime — Length of time in minutes, for which a RADIUS server is skipped over by transaction requests. (Range: 0 -
2000)
Default Configuration
The default dead time is 0 minutes.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example sets a dead time where a RADIUS server is skipped over by transaction requests for this period, to 10
minutes.