Planet Technology WGSW-48040 - Manual (Page 306)

User’s Manual of WGSW-24020/WGSW-48040
-30
5.23.3 telnet
The telnet User EXEC command is used to log in to a host that supports Telnet.
Syntax
telnet ip-address | hostname [port] [keyword1......]
ƒ ip-address — IP address of the destination host. An out-of-band IP address can be specified as described in the usage
guidelines. (Range: 1 - 160 characters)
ƒ host — Hostname of the destination host (Range: Valid IP Address)
ƒ port — A decimal TCP port number, or one of the keywords from the ports table in the usage guidelines. The default is
the Telnet port (decimal23) on the host.
ƒ keyword — Can be one or more keywords from the keywords table in the User Guidelines.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
The Telnet software supports special Telnet commands in the form of Telnet sequences that map generic terminal control
functions to operating system-specific functions. To issue a special Telnet command, enter Esc and then a command character.
If you want to login to host on the out-of-band port, use the out-of-band IP address format: oob/ip-address.
Special Telnet Command character
Escape Sequence Purpose
Ctrl-shift-6 b Break
Ctrl-shift-6 c Interrupt Process (IP)
Ctrl-shift-6 h Erase Character (EC)
Ctrl-shift-6 o Abort Output (AO)
Ctrl-shift-6 t Are You There? (AYT)
Ctrl-shift-6 u Erase Line (EL)
At any time during an active Telnet session, the Telnet commands can be listed by pressing the Ctrl-shift-6 key, followed by a
question mark at the system prompt: Ctrl-shift-6 ?
A sample of this list follows.
The following example displays the system service tag information.