13 show bridge address-table, Syntax, Default configuration – Planet Technology WGSW-48040 User Manual
Page 167: Command mode, User guidelines, Example
User’s Manual of WGSW-24020/WGSW-48040
-16
port. Use the no form of this command to delete the MAC addresses.
Syntax
port security routed secure-address mac-address
no port security routed secure-address mac-address
mac-address — Specify a MAC address.
Default Configuration
No addresses are defined.
Command Mode
Interface configuration (Ethernet, port-channel). Cannot be configured for a range of interfaces (range context).
User Guidelines
The command enables adding secure MAC addresses to a routed ports in port security mode. The command is available when
the port is a routed port and in port security mode. The address is deleted if the port exits the security mode or is not a routed
port.
Example
In this example, the MAC-layer address 66:66:66:66:66:66 is added to port g1.
console (config)# interface ethernet g1
console (config-if)# port security routed secure-address 66:66:66:66:66:66
5.4.13 show bridge address-table
The show bridge address-table privileged EXEC command displays all entries in the bridge-forwarding database.
Syntax
show bridge address-table
[vlan vlan] [ethernet interface | port-channel port-channel-number]
vlan — Specific valid VLAN, such as VLAN 1.
Interface — A valid Ethernet port.
port-channel-number — A valid port-channel number.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.