2 network settings – Planet Technology WGSW-48040 User Manual
Page 32
User’s Manual of WGSW-24020/WGSW-48040
-32-
4.2.2 Network Settings
The Basic Setup Table include the Network Settings (see figure 4-7), which allows you to assign DHCP or static IP settings to
interfaces and assign default gateways. In the Networking Setting screen, you can set these parts as below:
Figure 4-7
Switch Network Setting screen
The page includes the following fields:
Identification:
System Name
Input the system name.
System Location
Input the location where the Switch is located.
System Contact
Input the administrative contact person.
System Object ID
The system object identifier is in this field.
Base MAC Address
Display the MAC address of the Switch.
IP Configuration:
Management VLAN
Allow to select the Management VLAN, the default Managemanet VLAN is VLAN 1.
IP Address Mode
Where select Static or Dynamic IP address configuration, the Default Mode is Static.
Host Name
This field allows input the DHCP Host Name.
IP Address
Allow input the IP address for a static address, the default IP Address is
192.168.1.254
.