Sony OXF-R3 - Manual (Page 61)

Chapter 4 Signal Paths
4-1
Chapter 4 Signal Paths
Chapter 4 – Signal Paths
The OXF-R3 system can be used to build a wide variety of signal paths
with maximum flexibility from a basic default configuration. Creating
configurations is simple. Signal paths created can be stored as Snapshots
to be copied and/or recalled later.
Chapter 4 Contents
4-1 The Basic (Default) Signal Path ...................................................... 4-2
4-2 Mix-Down Signal Path with Processing Inserted ........................... 4-4
4-3 Mix-Down with Post Channel Fader Insert ................................ 4-6
4-4 Recording to a Multitrack ............................................................ 4-7
4-5 In-Line Channel Multitrack Recording Set-up .......................... 4-8
4-6 In-Line Channel with Insert Post Channel Fader
(Monitor Function) ........................................................................ 4-9
4-7 SEND 1 Pre Fader Headphones Feed ........................................... 4-10
4-8 SEND 1 Post Fader Headphones Feed ...................................... 4-11
4-9 Broadcast Mode ............................................................................. 4-12
4-10 Channel Metering ........................................................................ 4-15
4-10-1 Channel Meter Default ..................................................... 4-15
4-10-2 Channel Meters to Input................................................... 4-15
4-10-3 Send Monitor ................................................................... 4-16
4-10-4 Return Monitor ................................................................ 4-16
4-10-5 MULTI in Channel Path .................................................. 4-17
4-11 Dynamics Side-Chain Linking ................................................... 4-18
4-11-1 Dynamics Side-Chain Link Right .................................... 4-18
4-11-2 Dynamics Side-Chain Busses 1-4 .................................... 4-20
4-12 Mixing to the Main Output Bus .................................................... 4-22
4-12-1 Main Output Bus Set-up .................................................. 4-24
4-12-2 Channel Signal to the Main Output ................................. 4-26
4-13 Multi-Stem Set-up ......................................................................... 4-29
4-13-1 Multi-Stem Set-up Procedure .......................................... 4-32
4-13-2 Multi-Stem Monitor Path ................................................. 4-36
4-13-3 Multi-Stem Source Channels ........................................... 4-40
4-13-4 Stem Monitor Switching .................................................. 4-48
4-13-5 Stem Monitor Switching GUI Set-up .............................. 4-50
4-13-6 Fold-Down Matrix GUIs.................................................. 4-52