Sony OXF-R3 - Manual (Page 281)

Chapter 7 Session Management
7-21
Chapter 7 Session Management
There are four ways to drop out of WRITE when dropping back to previous moves. The buttons for these four
modes are on the mid right part of the panel at the base of the central LCD.
1 BUTT - (default) Where a jump occurs at the
drop-out point.
2 RAMP - Where a user defined time is taken to
slew to the previous move. (Set the time in
MIXES & CUES GUI).
3 AUTO-TAKE - Where the operator manually
fades to the previous move.
4 TO END - Where the fader position at the drop-
out point is recorded to the end of the Title for both
absolute and trim functions.
Central LCD Screen panel layout
These four buttons inter-cancel but it is possible to use
different modes on different faders. This is achieved
by working in one mode first and then rolling back to
use another mode on other faders. Different modes
can be used on the same fader at different times.
5 TO TOP Push-Button
A related function allowing fader position to be
recorded from any point within the Title to the
beginning, for both absolute and trim. If a fader is in
record then it is the point at which {TO TOP} is pressed
which determines the level. If {TO TOP} is already on
then it is the point the fader is dropped into record.
7-5-7 Dropping Out of Write on Subsequent Mix Passes
AUTO
TAKE TOUCH
WRITE
SELECT
TOUCH
HOLD
TOUCH
CLEAR
TO
END
BUTT RAMP
READY
ABSOLUTE
READY
TRIM
READY
CANCEL
1 2 3 4
ISOL
ON
AUTO
ISOL
AUTO
ISOL
CANCEL
AUD-
ITION
TO
TOP
ROLL
BACK
JOIN
AUTO
OFF
5