Sony OXF-R3 User Manual
Page 272
7-12
Chapter 7
Session Management
Chapter 7 Session Management
7-5 Mixing Overview
To set a cue point offline
1
Move the orange highlight to the desired line in the
TIME column on the screen.
2
Click or press {EDIT} on the Control Keyboard.
Type in the timecode and click OK or press
{ENTER} on the Control Keyboard.
To adjust the time of a cue point offline
1
Move the orange highlight to the TIME column on
the screen and nudge the time with the { + } and
{ - } keys, or:
2
Click on the time entry or press {EDIT} on the
Control Keyboard to display the timecode dialogue
box. Type in the timecode and click OK or press
{ENTER} on the Control Keyboard.
Using the Numeric Key-pad to Enter Timecode
The entry format is exactly the same as that used for
PCM-3324/48 series remote control units:
1
= 00:00:01:- -
12
= 00:00:12:- -
1234
= 00:12:34:- -
12345
= 01:23:45:- -
123456
= 12:34:56:- -
12345621
= 12:34:56:21
12:34:56:21
= 12:34:56:21
12:34:56
= 12:34:56:- -
Timecode shortforms:
::
Separates hours/minutes
:
Separates minutes/seconds
.
Separates seconds/frame
12::
= 12:00:00:00 Specifies hours
34:
= 00:34:00:00 Specifies minutes
56
= 00:00:56:00 Specifies seconds
.21
= 00:00:00:21 Specifies frames
To obtain a rough balance
1
On the Control Keyboard, press:
{CYCLE} {TITLE}
{ENTER}
The source material will be repeated over and over
again between the Start and End times allowing a
fader balance to be created.
Alternatively, press:
{CYCLE} {CUE} # {CUE} # {ENTER}
to use cue numbers for the selection.
2
Stop the tape when required using the Machine
Remote transport
p stop key or press {CANCEL}
on the Control Keyboard.
3
To repeat the operation, press:
{REPEAT} {ENTER} on the Control Keyboard.