Sony OXF-R3 - Manual (Page 331)

Chapter 7 Session Management
7-71
Chapter 7 Session Management
To set up Cuts for automation locally
See the diagram - ‘Setting automation of Cuts locally’.
1
The {ABS} and {TRM} buttons above the faders are
assigned to the faders by default.
{ABS + TRM TO FADs} will be lit to indicate this.
2
Press {ABS + TRM TO CUTs} to assign the {ABS}
and {TRM} buttons to the cuts.
3
Press {ABS} for the cuts to be automated where
new data is to be written. This will overwrite
previous data.
4
Their red LEDs flash to indicate their ‘ready’
status.
5
Press {TRM} for cuts to be automated where cut
data is to be modified or added to.
6
Their green LEDs will flash to indicate their
‘ready’ status.
7
To set a bank of 24 cuts into ‘ready’ status, press
and hold {CHS 1-24}, for example, until it turns
amber and then press any {ABS} or {TRM}.
Automation master keys
TO
END
CANCEL
READY
ABSOLUTE
READY
TRIM
READY
AUTO
TAKE
BUTT RAMP
SELECT
TOUCH
HOLD
TOUCH
CLEAR
. : 0
3 2 1
4 5 6
9 8 7
TOUCH
WRITE
F1 F2 F3 F4 F5 F6 F7 F8
R
E
T
N
E
CYCLE
A B
PLAY
TITLE MIX CUE
LOCATE
GLOBAL
SAVE
DROP-IN
GLOBAL
DROP - OUT
COPY DELETE
BACK
SPACE
AS
NEW
F
SET
KEY
PRINT
EDIT
ALL
UNDO
UNDO REDO
PROJECT
SNAP-
SHOT
LOAD
REDO
ALL
NOW TO
CANCEL REPEAT
SELECT
MACH
3
4
5
2 1
MAKE
STATIC
MERGE
(SPARE)
(1)
JOG
AUD-
ITION ISOL
ON
AUTO
ISOL
AUTO
ISOL
CANCEL
ROLL
BACK
JOIN
TO
TOP
GLOB
ISOL
To set up Cuts for automation using the central master keys
1 READY ABSOLUTE Push-Button
This latching button allows the user to set cuts into an
‘automation ready’ state where new cuts can be written
which will overwrite previous data. If any cuts were
already lit, their lights will go out for the set-up during
the period that {READY ABSOLUTE} is latched. Latch {READY ABSOLUTE} and press any cuts to be
automated and they will flash to show that they are
enabled. When {READY ABSOLUTE} is pressed again,
de-selecting it, the enabled cuts return to their previous
states. Rolling the tape causes {READY ABSOLUTE} to
be de-selected automatically.