Sony OXF-R3 - Manual (Page 365)

Chapter 7 Session Management
7-105
Chapter 7 Session Management
USE LOCATES FOR JOGGING
• Sets an alternative method for jogging remote machines. In this mode the
JOG SPEED preference is ignored and the JOG TRIGGER has an
increased effect on the sensitivity of the Jog Wheel.
POINTER Tab
INDEPENDENT TRACKERBALLS
• Sets the two Trackerballs to operate independently. The left Trackerball
controls the cursor or pointer in the 3 LCDs on the left of the console
whilst the right controls the 3 LCDs on the right plus the central LCD.
Pressing {SELECT} under the central LCD will put its cursor control
under the right Trackerball. The left Trackerball cursor can be moved
into the central LCD too, but by manual control only. This allows either
or both Trackerballs to control the central LCD cursor. If both
Trackerballs are controlling the central LCD then the last one moved
takes precedence.
TRACKERBALL SPEED
• Sets the gearing ratio of the Trackerball movement to cursor movement,
1 being the slowest and 8 the fastest.
DIAGS Tab
PRINT TIMECODE WARNINGS TO GUI
• Displays Timecode error messages, such as drop-outs, on the centre LCD.
SHOW TIMECODE GLITCHES
• Displays non-contiguous or jumps in Timecode.