Sony OXF-R3 - Manual (Page 282)

7-22
Chapter 7 Session Management
Chapter 7 Session Management
7-5 Mixing Overview
This functions in exactly the same way as for one fader
except that once the desired faders are in ‘ready ABS’
mode, they may be put into full WRITE individually
using their local WRITE buttons, or simultaneously
using the {GLOBAL DROP-IN} button on the Control
Keyboard.
{GLOBAL DROP-OUT} takes all faders out of WRITE
as with cuts.
Put the desired Faders into ready trim locally by
pressing the {TRM} buttons by the faders, and use
either local WRITEs or {GLOBAL DROP-IN} and
{GLOBAL DROP-OUT} to action the recording of
moves.
Select {TRM} locally for the desired fader, and its green
LED flashes. Press the WRITE button in the fader
knob before starting the tape or while it is rolling and
the LED goes on solid, indicating that moves will be
recorded.
If the tape is rolling, previous moves will be heard and
displayed on the fader before the knob is touched.
The moves will still be heard if the fader is touched
and moved.
The previous moves will be heard whether or not
WRITE has been pressed.
This also applies to TOUCH WRITE where WRITE
buttons in fader knobs have been used to latch
automation record.
Use the {READY CANCEL} button below the central
LCD to drop all controls completely out of automation
record.
7-5-8 To Record Absolute Moves for a Number of Faders
7-5-9 To Trim Fader Moves
Before pressing WRITE, move the fader knob to a
suitable part of the fader scale with good resolution.
This will become the null point around which TRIM
fader moves can be trimmed, at the moment WRITE
is pressed. The ‘0’ position is recommended as a good
reference point for trimming moves.
Any trimmed moves will add or subtract from the null
point according to the fader scale. Dropping out of
TRIM functions in the same way as coming out of
ABS mode.
Select {SHOW VALUE} at the SELECT TO FADERS
panel to display fader gain settings in dBs on the
electronic scribbles.
The steps to save a mix are as previously described in
Section 7-5-5.
7-5-10 To Trim Moves for a Number of Faders