Sony OXF-R3 - Manual (Page 218)

6-56
Chapter 6 Technical Descriptions
Chapter 6 Technical Descriptions
6-3 Central Section Panels
2
Adjust the definable knob to change the delay factor for all channels.
The delay is displayed in ms or samples. Use { + } and { – }
buttons either side of the display to change the parameter type. The
knob normally operates in a fine-tune mode. Press and hold the knob
whilst turning it for coarse adjustments.
3
To isolate individual channels from the Global Delay adjustment,
select {SET GLOBAL DELAY} but before making any adjustments, press
the {ACCESS} buttons on the individual channels. Those channels will
remain at their current Global Delay setting.
4
De-select {ACCESS} buttons and select others if necessary, or release
{SET GLOBAL DELAY} to return to normal operations.
To reset Global Delay, select {SET GLOBAL DELAY} and then press and
hold the { + } and { – } buttons, either side of the display above the
definable knob, for at least 2 seconds.
Channel Delay
Channels have local Delay control allowing offsets from Global Delay. To
adjust the local Delay:
5
Select {ACCESS} for the channel to be adjusted. Select {DELAY} at the
FREE ASSIGN AREA & DYNAMICS panel.
6
Adjust the knob labelled ‘GLOBAL DELAY’ at the right hand side of
the panel. The offset value will be displayed whilst the knob is
adjusted, and for a few seconds after its release. For continuous
display of the offset value, click on ‘ALWAYS’ on the GDC
DISPLAY option in the PREFS GUI (see Chapter 5 for details).
2 MIN DELAY Push-Button
The processing delay in the SP system has no compensation. In other
words, the delay through any channel is at its minimum, totally dependent
upon the amount of processing inserted in that channel.
3 AUTO DELAY Push-Button
Delay compensation is inserted in the SP system for all channels according
to the processing of the channel with most processing, and hence the
longest delay, in order that the outputs of all channels are time-aligned.
4 FREEZE DELAY Push-Button
The delay compensation factor in the SP system is fixed for all channels
according to the delays in operation at the time FREEZE DELAY is
latched.